Grinding - The best method by a long shot

For nearly 50 years, scarifying and shot blasting machines have looked and functioned the same. For those who still believe that these methods are the smartest way of machining a floor, it’s time to think again.

The development of HTC’s machines and tools means that there is no longer any reason at all for continuing to use old-fashioned methods and equipment.

Users of HTC’s equipment around the world who have kept up with developments save both time and money when they start to use modern equipment – and HTC is leading the trend.

Grinding

Functions on all surfaces
Many areas of use
A flat surface can always be achieved
Close to edges
Low noise level and little dust

Scarifying / Shot blasting

Impossible to get a flat surface. Grinding or self-levelling compound is required afterwards
Leaves lines that can often be seen under the covering
Extra covering material is required
Leaves 70-90 mm from the wall
Lots of dust, vibrations and noise
Few areas of use